Od dana 01.05.2015 u cilju razmjene iskustava, informacija i znanja forum je djelomično dostupan i neregistriranim članovima!
0 Članova i 1 Gost pregledava ovu temu.
The grey plastic tag on the keys IS NOT the EKA code, it is the ignition key code.
Using the ignition key insert it into the drivers door lock. Turn the key clockwise to the locking position (the doors will lock) and hold it in this position for at least 5 seconds. After 5 seconds slowly return the key to a central upright position. The first digit - Turn the key fully, as far as it can go, anticlockwise to the unlock position (the doors will unlock) then back to the central upright position. This should be done the amount of times as the first digit on your security card. The second digit - Turn the key fully, as far as it can go, clockwise to the lock position then back to the central, upright position. This should be done the amount of times as the second digit on your security card. The third digit - Turn the key anticlockwise to the unlock position again, the number of times shown on the security card The fourth digit - Turn the key clockwise to the lock position again, the number of times shown on the security card. Once this has been completed turn the key to the unlock position once. If the code has been entered correctly, open the door and the red flashing LED light on the dashboard will . You will now be able to start the vehicle.
Btw tu lijepo piše da ide 1 x CR 2032 a ne 2 x CR2016.